Bosch DPH30652UC Installationshandbuch PDF herunterladen (Seite 10)

10

Top

outlet

Top

screw

location

Square

slot

bottom fixing

screws locations

Top

screw

location

Rear

outlet

7 1/2"

W

Z

K

Knockouts

(junction

box)

Wall Mount Installation

Note: see below if cabinet installation is

preferred

4. After the hood installation height has been

determined draw a horizontal line at a

distance above the cooktop equal to the

desired hood installation height plus 7- 1/

2”. See also Figure 6a.

5. Find the centerline of the cooktop.

Draw a vertical line along this centerline up to

the horizontal line drawn in step 1 and draw a

vertical line right and left at a distance of

12-5/8” to determine the mounting location

of the mounting hooks shipped with the hood.

6. Fit two mounting hooks on the wall to hang the

hood through the provided slots (2 wall

anchors+2 hooks + 2 screws 5x35).

7. Run 8” Duct , long enough to reach the

transition once the hood has been installed plus

1 1/2” inch to connect ductwork.

Fix Duct to transition with screws and seal with

tape.

8. Remove 1 of 2 knockouts and install 1/2”

conduit connector in j-box.

9. Hang the hood and adjust its position through

the screws on the hooks.

10.Fix the hood to 4 additional point,2 on upper

side, 2 on lower side (use 4 wall anchors + 4

washers + 4 screws 5x35.

11. Vertical discharge

Cabinet Installation:

Note: see above if wall mount installation is

preferred

Note: distances on Table 3.

4. Find the centerline of the cabinet bottom. Draw

a line along this centerline from rear to front of

the cabinet.

5. Draw two lines, one at a K distance from the

wall, the other one at a Z distance from the

previous line.

Mark 4 points , two along each line at a distance

of half W from the center line, to determine the

screw locations.

6. Fit 4 screws on cabinet bottom do not tighten

completely but leave a space of about 1/2” from

cabinet bottom surface and head screws.

7. Run 8” Duct , long enough to reach the

transition once the hood has been installed plus

1 1/2” inch for connect ductwork.

8. Remove 1 of 2 knockouts and install 1/2”

conduit connector in j-box.

9. Hang the hood on screws through side slots

provided on hood top.

Tighten the four screws.

Note: If possible fix the hood on the wall at 4

additional point (2 on upper side, 2 on lower

side).

10.From the inside of the cabinet attach the

transition on upper outlet (vertical discharge -

see also „Assembly of the 8” Transition“ on

previous pages)

HOOD WIDTH DIM. "W" DIM. "K" DIM. "Z"

30" 29 - 1/8" 2 - 1/2" 7 - 1/16"

36" 35 - 1/16" 2 - 1/2" 7 - 1/16"

Table 3

Side slot x 4

Figure 6b

K

CL

Z

W

CL

Screw for

cabinet

bottom

installation

Hook for wall

installation

Adjusting

screw

25 3/16"

7 1/2"

Bottom of the Hood

12 5/8"

12 5/8"

Figure 6a

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Kommentare zu diesen Handbüchern

Keine Kommentare