Bosch DGSH181BL Gebrauchs- und Pflegehandbuch PDF herunterladen (Seite 11)

Slide charged battery pack into the housing

until the battery pack locks into position

(Fig. 3).

Your tool is equipped with a secondary locking

latch to prevent the battery pack from

completely falling out of the handle, should it

become loose due to vibration.

To remove the battery pack, press the battery

pack release button and slide the battery pack

forward (Fig. 3).

Press the battery pack release button again

and slide the battery pack completely out of

tool housing (Fig. 3).

"!#!"##!( 

1. The charger was designed to fast charge

the battery only when the battery temperature

is between 32˚F (0˚C) and 113˚F (45˚C). If the

battery pack is too hot or too cold, the charger

will not fast charge the battery. (This may

happen if the battery pack is hot from heavy

use). When the battery temperature returns to

between 32˚F (0˚C) and 113˚F (45˚C), the

charger will automatically begin charging.

2. A substantial drop in operating time per

charge may mean that the battery pack is

nearing the end of its life and should be

replaced.

3. Remember to unplug charger during storage

period.

4. If battery does not charge properly:

a. Check for voltage at outlet by plugging in

some other electrical device.

b. Check to see if outlet is connected to a

light switch which turns power “off” when lights

are turned off.

c. Check battery pack terminals for dirt.

Clean with cotton swab and alcohol if necessary.

d. If you still do not get proper charging,

take or send tool, battery pack and charger to

your local Bosch Service Center. See “Tools,

Electric” in the Yellow Pages for names and

addresses.

8=. Use of chargers or battery packs not

sold by Bosch will void the warranty.

 !##!#"

-11-

##!(!#

#!#"

8-.5##875B

Your battery is equipped with charge condition

indicator lights (Fig. 4). The indicator lights

shows the charge condition of the battery

during operation.

To check the charge condition, press and hold

the charge condition indicator button with the

tool in the off position.

 *9*,2=B

Continuous lighting 3 x green > 2/3

Continuous lighting 2 x green > 1/3

Continuous lighting 1 x green < 1/3

Flashing light 1 x green reserve

CHARGE

CONDITION

INDICATOR

BUTTON

BATTERY CHARGE

CONDITION INDICATOR

LIGHTS

FIG. 3

FIG. 4

Practice on scrap materials first to see how the

tool performs. Keep in mind that the work is

done by the speed of the tool and by the

accessory in the collet. You should not lean on

or push the tool during use.

Instead, lower the spinning accessory lightly to

the work and allow it to touch the point at which

you want grinding to begin. Con centrate on

guiding the tool over the work using very little

pressure from your hand. Allow the accessory

to do the work.

Usually, it is best to make a series of passes

with the tool rather than attempt to do all the

work in one pass.

BM 3609929C20 08-11:BM 3609929C20 08-11.qxp 8/31/11 8:47 AM Page 11

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 43 44

Kommentare zu diesen Handbüchern

Keine Kommentare