Bosch PST 670 Wartungshandbuch PDF herunterladen (Seite 24)

24 | English

1 609 929 L18 | (20.2.08) Bosch Power Tools

Laser Module (PST 670 L/PST 700 PEL)

Inserting/Replacing the Laser Module Batteries

Insert the supplied batteries 15 into the laser

module 14 before starting operation for the first

time.

To open the battery lid 16, pull the latch 17 and

remove the battery lid. Insert the batteries. Pay

attention to the correct polarity according to the

representation on the battery lid.

Always replace all three batteries 15 together.

Use only LR44 batteries from the same manufac-

turer and with the same capacity.

Attaching/Removing the Laser Module

Insert the laser module 14 with the inside noses

engaging into the notches on the casing of the

power tool and push it down to the stop.

To remove the laser module, push it upward and

remove it from the casing.

f The laser module must be removed from the

power tool when used for stationary work

or when sawing from below a workpiece.

One can easily be blinded from the laser

beam when carrying out such work.

Splinter Guard (see figure C)

The splinter guard 21 (accessory) can prevent

fraying of the surface while sawing wood. The

splinter guard can only be used for certain saw

blade types and only for cutting angles of 0°.

When sawing with the splinter guard, the base

plate 5 must not be moved back for cuts that are

close to the edge.

Press the splinter guard 21 from the bottom into

the base plate 5.

Operation

Operating Modes

f Before any work on the machine itself, pull

the mains plug.

Orbital Action Settings

(PST 700 PE/PST 700 PEL)

The four orbital action settings allow for optimal

adaptation of cutting speed, cutting capacity

and cutting pattern to the material being sawed.

The orbital action can be adjusted with the ad-

justing lever 6, even during operation.

The optimal orbital action setting for the respec-

tive application can be determined through

practical testing. The following recommenda-

tions apply:

– Select a lower orbital action setting (or switch

it off) for a finer and cleaner cutting edge.

– For thin materials such as sheet metal,

switch the orbital action off.

– For hard materials such as steel, work with

low orbital action.

– For soft materials and when sawing in the

direction of the grain, work with maximum

orbital action.

Adjusting the Cutting Angle (see figures D

–F)

The base plate 5 can be swivelled by 45° to the

left or right for mitre cuts.

PST 700 PE/PST 700 PEL: If required, remove

the dust cover 11 (see “Dust Cover”).

PST 670 L: Insert a saw blade 10.

Loosen the screw 23 and lightly slide the base

plate 5 toward the vacuum connection 4.

For adjustment of precise mitre angles, the base

plate has adjustment notches on the left and

right at 0°, 22.5° and 45°. Swivel the base plate

5 to the desired position according to the scale

25. Other mitre angles can be adjusted using a

protractor.

No orbital action

Small orbital action

Medium orbital action

Large orbital action

OBJ_BUCH-354-005.book Page 24 Wednesday, February 20, 2008 10:44 AM

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 150 151

Kommentare zu diesen Handbüchern

Keine Kommentare

Bosch PST 670 Wartungshandbuch Seite 24

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kreissägen Bosch PST 670