Bosch VJD-3000 Installationshandbuch PDF herunterladen (Seite 12)

Installation

Preparations

VIDEOJET decoder 3000 and the power supply unit are both intended for use indoors or in

housings. Select a suitable location for installation that guarantees to meet the environmental

conditions.

You may use the unit as a desktop device or wall-mounted using the mounting material

supplied. For installation in a switch cabinet, you can obtain a rack mount kit for up to three

units. For more information access your Bosch product catalog on the Internet.

Caution!

The ambient temperature for the delivered power supply unit must be between 0 and +40 °C

(+32 and +104 °F). The relative humidity must be between 20% and 80%. The ambient

temperature for the unit must be between 0 and +50 °C (+32 and +122 °F). The relative

humidity must not exceed 90%.

The unit and the power supply unit generate heat during operation, so you should ensure that

there is adequate ventilation and enough clearance between both units and heat-sensitive

objects or equipment. Please note the maximum heat value of 31 BTU/h per unit without the

power supply.

Please ensure the following installation conditions:

– Do not install the unit or the power supply unit close to heaters or other heat sources.

Avoid locations exposed to direct sunlight.

– Allow sufficient space for running cables.

– Ensure that both the unit and the power supply unit have adequate ventilation. Bear the

total heat output in mind, particularly when installing multiple units in a switch cabinet.

– When making connections, use only the cables supplied or use appropriate cables

immune to electromagnetic interference.

– Position and run all cables so that they are protected from damage, and provide adequate

cable strain relief where needed.

– When installing in a switch cabinet, ensure that the screw joints are free of tension and

subject to as little mechanical stress as possible. Ensure that the unit and the power

supply unit have sufficient grounding.

– Avoid impacts, blows, and severe vibrations that exceed the specification limits, as these

can irreparably damage the unit.

Mounting

You can secure the unit to walls, below ceilings or any other load-bearing locations using the

wall-mounting panel, in either a vertical or a horizontal position.

Caution!

The mounting location must be able to reliably hold the unit. The load-bearing capacity must

be adequate for four times the weight of the unit.

If mounting the unit in a vertical position, you will need to use the lower plastic frame and

then place the unit onto the frame from above. If mounting the unit in a horizontal position,

you can use either of the two frames.

1. Lift the plastic frame on one side of the housing and carefully remove it from the unit.

2. Screw the plastic frame in the required position together with the wall-mounting panel.

4.1

4.2

12 en | Installation VIDEOJET decoder 3000

2014.01 | V4 | F.01U.296.741 Installation Manual Bosch Sicherheitssysteme GmbH

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 33 34

Kommentare zu diesen Handbüchern

Keine Kommentare

Bosch VJD-3000 Installationshandbuch Seite 12

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung Bosch VJD-3000