
Praesideo PRS-CSM / PRS-CSRM / PRS-CSKPM en | 8
Bosch Security Systems B.V.
IUI PRS-CS(R)(KP)M | V1.0 | 2013.12
Installation and User Instructions
1.2.3 Loudspeaker/Control Inputs (3)
This 6-pin connector provides the connection to a
loudspeaker and to two control inputs.
The control inputs can be configured to act on contact
make or on contact break (see section 43.4.7 of the IUI
Praesidio 4.0). It is also possible to supervise the cables
for short-circuits and open connections (see figure 1.6
and figure 1.7). Whether a control input is actually
supervised or not is defined in the configuration.
1.2.4 Headset/Volume control (4)
This 6-pin connector provides the connection to the
headset and the volume control. This volume control
also controls the volume of the loudspeaker connected
to connection 3.
A linear potentionmeter R (typical value: 100 kohm) is
used to create a control voltage from the supply voltage.
If a volume control is not needed, pin 2 and 3 must be
connected to each other. The volume level of the
earphone or loudspeaker is then at its maximum.
table 1.3: Loudspeaker/ Control Input connector details
Pin Signal
1 Speaker +
2 Speaker -
3 Control input 1
4 Return control input 1
5 Control input 2
6 Return control input 2
figure 1.6: Supervised control input
figure 1.7: Non-supervised control input
10k:
10k:
RTN Control input
RTN Control input
Warning
Do not connect DC or AC signals to the control
inputs, otherwise the input circuit may be
damaged. Only use voltage-free contacts.
Note
Do not combine control input wires of multiple
control inputs (e.g. do not use a common return
wire).
table 1.4: Headset/Volume Control connector details
Pin Signal
1 Headset (mic +)
2 GND (mic -)
3 Volume control voltage
4 3.3 V supply output
5 GND (earphone -)
6 Earphone +
figure 1.8: Headset connection diagram
Microphone
R
Earphone
Volume
Headset
1
2
3
4
5
6
Kommentare zu diesen Handbüchern