Bosch D9210C Spezifikationen PDF herunterladen (Seite 16)

16 en | Installation Access Control Interface Module

F.01U.215.244 | 05 | 2012.06 Installation and Operation Guide Bosch Security Systems, Inc.

Figure 3.2 Terminal locations

Point Sensor Loop. Install a 1 kΩ resistor at the door contact, not at the terminal of the input.

This will provide supervision against grounds on the loop. Connect only one contact, that

being the door, to this input.

Point Tolerance. Section Table 3.2 Point Tolerance Voltages, page 17 shows the voltages

that determine the condition of the on-board point. Use the point common as your (-)

reference when measuring the point (+). Set your meter for 10 to 24 VDC range.

Callout Description Callout Description Callout Description

1 PWR 8 T+ 15 5.2V

2A 9COM16DATA0

3 B 10 ZN+ 17 DATA1

4 COM 11 RTE 18 BUZZER

5NC 12COM19LED

6C 13REX

7 NO 14 12V

NOTICE!

See the D9210C Access Interface Module Program Entry Guide for assigning a point to the door

controller and the control panel Program Entry Guide for the point types.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 31 32

Keine Kommentare

Bosch D9210C Spezifikationen Seite 16