Bosch CS5 Spezifikationen PDF herunterladen (Seite 9)

DEPTH ADJUSTMENT

Disconnect plug from power source. Loosen

the depth adjustment lever located in the

housing of saw. Hold the foot down with one

hand and raise or lower saw by the handle.

I=1[_I[_!

DEPTH

BRACKET

Tighten lever at the depth setting desired.

Check desired depth (Fig. 3).

Not more than one tooth length of the blade

should extend below the material to be cut, for

minimum splintering (Fig. 4).

m

DEPTH

LEVER

BLADEWRENCH

&STORAGEAREA

ONETOOTHLENGTHSHOULD

PENETRATEWOODFOR

MINIMUMSPLINTERING

90 ° CUTTING ANGLE CHECK

Disconnect plug from power source. Set foot to

maximum depth of cut setting. Loosen bevel

adjustment lever, set to 0 ° on quadrant,

retighten lever and check for 90 ° angle

between the blade and bottom plane of foot

with a square (Fig. 5). Make adjustments by

turning the small alignment screw, if necessary.

BEVEL J_

ADJUSTMENT 90° ....__ __

LEVER

---ALIGNMENT

SCREW

LFOOT

BLADE

BEVEL ADJUSTMENT

Disconnect plug from power source. The foot

can be adjusted up to 56 ° by loosening the

bevel adjustment lever at the front of the saw.

Align to desired angle on calibrated quadrant.

Then tighten bevel adjustment lever (Fig. 6).

Because of the increased amount of blade

engagement in the work and decreased

stability of the foot, blade binding may occur.

Keep the saw steady and the foot firmly on the

workpiece.

BEVEL

ADJUSTMENT

LEVER

QUADRANT

-9-

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 39 40

Kommentare zu diesen Handbüchern

Keine Kommentare