Bosch VideoJet 8008 Bedienungsanleitung PDF herunterladen (Seite 50)

Installation and Operating Manual | VideoJet 8008

EN | 50

Configuration using a Web Browser Bosch Security Systems | 2005-06 | V2.0

Video loss alarm:

Click the check box if you want interruption of the video signal to trigger an

alarm. A selected video input is marked with a tick.

Note

The numbering corresponds to the labeling of the video inputs on the rear

panel of the unit.

Alarm connections

You can select the response of the VideoJet 8008 in case of an alarm. In case of

an alarm, the VideoJet 8008 can automatically establish a connection to a

predefined IP address. You can enter up to ten IP addresses which will be

selected in order by the unit in case of an alarm until a connection is established.

You can also choose which camera image should automatically be displayed

first on the receiver in case of an alarm.

Connect on alarm:

Select On so that the VideoJet 8008 automatically establishes a connection to

a pre-defined IP address in the event of an alarm.

Note

For alarm connections, always Stream 2 is transmitted. Take this into

account when assigning the profile (see page 32).

Number of destination IP address:

Here you assign the numbering for the IP addresses to be contacted in the event

of an alarm. The unit contacts the remote locations one after the other in the

numbered sequence until a connection has been established.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 135 136

Keine Kommentare

Bosch VideoJet 8008 Bedienungsanleitung Seite 50