Bosch GSN Spezifikationen PDF herunterladen (Seite 15)

English | 29

Bosch Power Tools 1 609 929 U15 | (8.12.09)

Correction of Malfunctions

Problem Cause Corrective Measure

The pneumatic tool is ready for

operation but no nails are dis-

charged.

A nail is jammed in the shot duct. – Clear the jam.

(See “Clearing Jams”, page 26)

The magazine slider is 7 defective. – Clean and lubricate the magazine slider

7 as required and make sure that the

magazine 8 is not dirty/soiled.

The spring of the magazine slider is too

week or defective.

– Contact an authorised service agent for

Bosch power tools.

Have the component replaced there.

The fasteners being used are not

permitted.

– Use only original accessories.

Only the fasteners (nails, staples, etc.)

specified in table “Technical Data” may

be used.

The magazine 8 is empty. – Refill the magazine.

(See “Loading the Magazine”, page 24)

The nails are discharged very

slowly and with too little pres-

sure.

The rated pressure of the compressed-

air supply is too low.

– Increase the compressed-air supply.

8 bar may not be exceeded.

The driver blade is damaged. – Use only the lubricants recommended

by Bosch.

(See “Lubricating the Pneumatic Tool”,

page 27)

The sealing ring of the piston is worn or

damaged.

– Contact an authorised service agent for

Bosch power tools.

Have the component replaced there.

The buffer is worn. – Contact an authorised service agent for

Bosch power tools.

Have the component replaced there.

The length and diameter of supply-air

hose 13 do not correspond with the data

of this pneumatic tool.

– Use a supply-air hose with the correct

dimensions.

(See “Technical Data”, page 23)

The supply-air hose 13 is bent/creased. – Correct the bend/crease in the supply-

air hose.

The nails are driven in too deep. The rated pressure of the compressed-

air supply is too high.

– Reduce the compressed-air supply.

4 bar may not be fallen below.

The depth stop is set too deep. – Adjust the depth stop to the desired

depth.

(See “Adjusting the Depth Stop”,

page 26)

The buffer is worn. – Contact an authorised service agent for

Bosch power tools.

Have the component replaced there.

OBJ_BUCH-1037-001.book Page 29 Tuesday, December 8, 2009 1:03 PM

1 2 ... 10 11 12 13 14 15 16 17

Kommentare zu diesen Handbüchern

Keine Kommentare

Bosch GSN Spezifikationen Seite 15

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein Bosch GSN