Bosch SPE53U52UC Installationshandbuch Seite 7

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 28
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 6
5
Enclosure Requirements
WARNING
Avoid Scalding or Electrical Shock Hazard!
Make sure the water supply and electrical supply are
shut off before installation or service.
NOTE: This dishwasher is designed to be enclosed on
the top and both sides by standard residential kitchen
cabinetry.
Select a location as close to the sink as possible for easy
access to water supply and drain lines. For proper
dishwasher operation and appearance, ensure that the
enclosure is square and has the dimensions shown in
Figure 1.
Figure 1
NOTE: If your dishwasher opening width measures >18
in (458 mm) use the TOP OR SIDE MOUNT mounting
methods. If your dishwasher opening width measures
17
7/10
- 18 in (450 - 458 mm) use the ALTERNATE SIDE
MOUNT mount-ing method.
If the dishwasher is to be installed in a corner, make sure
that there is adequate clearance to open the door. See
Figure 2.
Figure 2
WARNING
Avoid Electrical Shock/Fire Hazard!
Do not allow the electrical and water supply lines to touch.
After locating the proper place for your new dishwasher,
you will need to create any required openings to allow for
passage of the water, drain and electrical line. In order to
avoid interference with the dishwasher when sliding it
into the cabinet, place your openings within the
dimensions shown in Figure 3.
Figure 3
Required Openings:
4
3/4
Ǝ x 2
3/8
Ǝ (120 x 60 mm) - To pass the included
electrical supply junction box through to adjacent cabinet.
NOTE: If the incoming electric supply, water supply and
drain connections are all in the same cabinet, the one
4
3/4
Ǝ x 2
3/8
Ǝ (120 x 60 mm) hole will be large enough for
all three to pass through.
4Ǝ x 2Ǝ (100 x 50mm) - To pass the included water supply
line toward the water supply.
1
1/4
Ǝ (32 mm) diameter - To pass the dishwasher drain
hose toward the drain connection.
Before sliding the dishwasher into the cabinet,
remove the hose clip at the back of the dishwasher
as shown in Figure 4. The hose clip may be used
later to hold the drain hose as shown in Figure 9.
Figure 4
Seitenansicht 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

Kommentare zu diesen Handbüchern

Keine Kommentare