Bosch D1255RB Installationsanleitung Seite 39
- Seite / 104
- Inhaltsverzeichnis
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
D9412GV2/D7412GV2 | Operation and Installation Guide | 9.0 Off-Board Points
.
Bosch Security Systems, Inc. | 7/09 | F01U003641-04 39
9.0 Off-Board Points
9.1 Point (Zonex) Bus: D9412GV2
Terminals and D7412GV2
Terminals
9.1.1 POPIT Modules
The D9412GV2 can use point of protection input
transponder (POPIT) modules to provide a maximum
of 238 off-board points, bringing the total number of
points the D9412GV2 can monitor to 246. The
D7412GV2 provides up to 67 off-board points,
bringing the total number of points the D7412GV2
monitors to 75. Each off-board point requires a POPIT
Module.
9.1.2 POPEX Modules
POPITs connect to supervised two-wire data
expansion loops run from POPIT to POPIT throughout
the premises. Data expansion loops connect to a
D8125 Point of Protection Expander (POPEX)
Module. POPEX Modules have power and data
connections to the point bus on the control panel
(Table 11).
Table 11: POPEX Modules
Model Power Data
D9412G Terminals 23 and 24
Terminals 25 and 26
or
Terminals 27 and 28
D7412G Terminals 23 and 24 Terminals 27 and 28
9.1.3 Missing Conditions
If a programmed POPIT is disconnected from the
expansion loop, a missing condition appears
immediately and the event is logged. The missing
condition might also be sent to a central station or
printed to an on-site printer, if programmed to do so.
Refer to the D9412GV2/D7412GV2 Program Entry
Guide (P/N: F01U003636) for programming options.
9.1.4 Extra Point Events
Extra Point events are generated when a POPIT
connected to the data expansion bus does not have
an assigned Point Index. Table 12 shows when an
Extra Point event is or is not generated. Table 13 on
page 40 shows additional error conditions that can
occur for the off-board points.
Table 12: Extra Point Events
A POPIT connected to the data
expansion bus does not have an
assigned Point Index and:
Extra Point event? Additional Information
Data expansion bus is disconnected No
Keypad does not annunciate or display a trouble
condition.
Data expansion bus restores to
normal condition after an open
condition
Yes
•
Keypad annunciates and displays a trouble
condition
•
Extra Point is logged and might be programmed to
send reports to the central station or to an on-site
printer.
Point input changes status from
normal to open or shorted
No
Keypad does not annunciate or display a trouble
condition.
During a Service Walk Test, the point
input changes status from normal to
open or shorted
Yes
∗
•
Keypad annunciates and displays a trouble
condition
• Extra Point is logged and might be programmed to
send reports to the central station or to an on-site
printer.
∗
The Service Walk Test never shows the electrical state of a point as “Extra.”
- D9412GV2 1
- D7412GV2 1
- Trademarks 2
- Certifications and Approvals 2
- Listings and Approvals 2
- Federal Communications 2
- Commission (FCC) Rules 2
- Contents 4
- 1.0 Introduction 7
- 2.0 Lightning Strikes 8
- 3.0 Overview 9
- 3.2 Accessories 10
- 4.0 Installation 15
- 4.5 Connecting Earth Ground 16
- Reset Pin 18
- Disable All Except Battery 18
- Charging And Programming 18
- 4.9 Testing the System 19
- 4.10 Service Walk Test 20
- 5.0 Power Supply 23
- LEDs Off When Normal 26
- Charging Status 26
- Low Battery 26
- 6.0 Power Outputs 28
- 1.4 A − NSC current 29
- Alarm current 29
- 7.1 Registration 30
- 7.2 Notification 30
- 7.3 Location 30
- Phone Cord Length 33
- D161 2.4 m (8 ft) 33
- D162 61 cm (2 ft) 33
- 8.2 Point Sensor Loops 35
- 8.3 Point Parameters 35
- 8.4 Point Response Time 36
- Using the Rothenbuhler 36
- 0.64 mm (1/4 in.) 37
- RED ORG WHT BL K 38
- 9.0 Off-Board Points 39
- Modules 40
- D9127U/TD9127U/T 41
- D9127U/T 41
- 23451 678 46
- S3 Option 49
- NOT USED 50
- NEX POWER + 50
- COMMON 23 50
- COM IN OUT+12V 51
- 9.5 Testing Off-Board Points 52
- 10.0 Off-Board Relays 53
- 1 2 3 4 567 8 54
- 11.0 Arming Devices 58
- 11.4 Keyswitch 60
- 12.0 SDI Devices 62
- 12.5 SDI Address 80 63
- 12.6 SDI Address 88 64
- 13.1 Programmer Connector 66
- 13.3 Accessory Connector 66
- A.1 D9412GV2 Control Panel 69
- Point 1 Point 2 70
- Point 3 Point 4 70
- Point 5 Point 6 70
- Point 7 Point 8 70
- A.2 D7412GV2 Control Panel 72
- Specifications 77
- Bosch Security Systems, Inc 78
- 130 Perinton Parkway 78
- Fairport, NY 14450-9199 78
- D1255/D1255B 79
- 1.0 Description 80
- 2.0 Digital Keypad 81
- 3.0 Installation 82
- 4.0 Specifications 83
- Bosch Security Systems 86
- DS1101i/1102i/1108i 87
- Glass Breakage Detectors 87
- Alarm/Test LED 88
- 48781-01 91
- PIR Signal 92
- Intrusion Detector 93
- Installationsanleitungen 96
- 㹿ࡼ㑶㒓⌟఼ᖂ 100
- ⊶ܹ։⌟఼ᅝ㺙䇈ᯢ 100
- Installation Instructions 101
- 6.0 LED Operation 102
- 9.0 Supervision Features 103
- 11.0 Coverage Pattern 104
- 10.0 Other Information 104
Verwandte Produkte und Handbücher für Ziffernblock Bosch D1255RB
(7 Seiten)© 2020, manymanuals.de. Alle Rechte vorbehalten. | 1.859 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern