Bosch D9412GV2 Bedienungshandbuch PDF herunterladen (Seite 17)

REMOTE PROGRAM?

Description

Your security company can remotely program your security system using the telephone line your

panel is connected to. Typical remote programming functions include: changing personal 7,

passcodes, changing entry/exit delays, resetting the system clock/calendar, and adding/deleting

system arming commands.

Your security company may ask you to follow the steps below to begin a remote programming

session. The time it takes to program the panel is dependent on the number of changes made to

the program.

You’ll notice that two sets of procedures are presented. Which one you use will depend upon

whether your system has a pre-programmed telephone number in its memory.

My system has a phone number.

My system does not have a phone number.

For systems without a phone number:

1. Ensure your security system is at idle text.

2. Call this phone number: . This number is designated for the

Remote Account Manager. You must make the call using the telephone located at

__________________________.

3. Identify yourself and your premises (account number, name, address, etc.) and advise the operator

of the services you wish to have performed.

4. When the operator directs you, enter COMMAND 43 at your command center. Press the

[COMMAND] bar. The display shows SYSTEM COMMAND. Now press the [4 ]key, then press

the [3] key. Do not hang up the telephone.

Note: If you prefer, you may use the Command Menu in place of steps 3 and 4 to initiate this function.

Press the [MENU] key to enter the Command Menu, then press [NEXT] repeatedly until you

reach the REMOTE PROGRAM ? prompt. Press [ENT].

5. The display shows RAM CONNECTING.

6. The security system will now disconnect telephones sharing its telephone line during the remote

programming session. Hang up the telephone now.

7. The display changes to SYSTEM PROGRAM.

8. At the conclusion of the programming session your system sends a report to the security company

and then returns your telephone to normal service and your display to idle text.

For systems with a phone number:

1 . Ensure your security system is at idle text.

2. Call this phone number:________________________________. This number is designated

for the Remote Account Manager.

3. Identify yourself and your premises (account number, name, address, etc.) and advise the operator

of the services you wish to have performed.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 71 72

Keine Kommentare

Bosch D9412GV2 Bedienungshandbuch Seite 17