Bosch D9412GV2 Bedienungshandbuch PDF herunterladen (Seite 51)

Move to Area

With this function you can perform tasks in an area other than the one you’re in without having

to physically go to that area. Your access to other areas is limited by the scope of the command

center and your authority level. For example, if your passcode gives you authority to all 8 areas,

but the command center you’re working with is limited in scope to areas 1 and 2, then you will

only be able to move to either area 1 or area 2.

Upon moving to another area, the range of tasks you may perform depends upon the command

center you’re working with. Once you’ve performed a task (such as Turning the Area On), the

command center reverts back to its programmed area after 10 seconds. Thus only one task can be

performed in another area at a time.

1. Ensure that your command center is at idle text.

2. Press the [COMMAND] bar. The display shows SYSTEM COMMAND.

3. Press the [5] key, followed by the [0] key. The display shows ENTER AREA. Enter the

area number you wish to move to. Press [ENT].

4. AREA X MOVE displays briefly, and then the text of the area you’ve moved to is

displayed. You are now able to perform tasks in this area. The number of areas to which

you can move will be limited by the scope of the command center. If you try to move to

an area for which the command center does not have scope, NO AUTHORITY is

displayed.

5. When you have completed all tasks in the area you’ve moved to, simply allow the

command center to time-out and revert to the area from which you started or enter the

Move to Area function again.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 71 72

Keine Kommentare

Bosch D9412GV2 Bedienungshandbuch Seite 51