Bosch 1943 LED Spezifikationen PDF herunterladen (Seite 5)

5Bosch Security Systems, Inc. | 09/06 | 31344F

4.0 Mounting

Do not use this product in outdoor

applications.

1. Install a 10 cm (4 in.) square or octagonal electrical

box (not supplied) to a rigid surface that is not

subject to movement or vibrations.

If you are not mounting these detectors to an

electrical box, ensure the surface cannot move or

vibrate. For example, do not mount the detector

directly to a suspended ceiling without extra

support.

2. Remove the screw on the receiver's access door.

Then remove the cover’s four screws (refer to

Figure 5).

3. Remove the receiver back plate by unscrewing the

single mounting screw from the top of the circuit

board carrier plate and separating the two plates

(refer to Figure 6).

4. Route the wiring from the electrical box through the

wire entrance.

Unpower (disable) all wiring.

5. Mount the back plate to the electrical box.

6. Attach the circuit carrier plate to the back plate

using a single mounting screw.

7. Repeat Steps 1 through 6 to mount the transmitter.

1 - Access door

2 - Cover mounting screw (4)

Figure 5: Access Door and Cover

1 - Remove screw to expose the back plate.

2 - Mounting slot (4)

3 - Wiring entrance

4 - Do not remove.

Figure 6: Removing the Back Plate

D296/D297 | Installation Instructions | 4.0 Mounting

1 2 3 4 5 6 7 8 9 10 ... 15 16

Keine Kommentare

Bosch 1943 LED Spezifikationen Seite 5