Bosch ISC-PDL1-WA18G Bedienungsanleitung PDF herunterladen (Seite 3)

2.3 Mounting the detector

Use the hardware provided. The plastic mounting anchors

require a 3/16 (5 mm) hole.

Surface mounting

�

1 Tamper Screw

Corner Mounting

2.4 Wiring the detector

Wire sizes between 16 AWG and 26 AWG (0.2 mm

and 1

) are permitted. Install the wiring using the approprate

knock-outs and tie-downs.

2.5 Wiring the terminal blocks

The detector has two terminal blocks. One block is used for

primary wiring; the other has two spare terminals. The two

spare terminals are normally used as tie points for the EOL

resistor.

     





�





 













Do not attempt to remove the terminal blocks from

the cover. This could result in permanent damage

to the detector.

1 2 3 4 5 6

Keine Kommentare

Bosch ISC-PDL1-WA18G Bedienungsanleitung Seite 3