Bosch DS7400XiV4-EXP Bedienungsanleitung PDF herunterladen

Control Panel DS7400XiV4-EXP

Release Notes January 2005

Release Notes for Firmware Version 4.10

Trademarks

Cobox™ is a trademark of Lantronix.

1.0 Remote Programming

Compatibility

Use RPS-INT’L version 3.7.140 or later to program

the DS7400XiV4-EXP control panel.

2.0 New Features in Firmware

Version 4.10

2.1 Network Communication

The control panel can be configured to communicate

over an Ethernet network. Reports can be sent over

this network from the control panel to the central

station receiver. Remote programming can also be

conducted over this network. A DX4020 Network

Interface Module (NIM) is required for network

communication. Refer to the DX4020 Network Interface

Module Installer’s Guide (P/N: 49522) for installation

and configuration instructions. Refer to Section 2.1.1

Network Communication Report Routing on page 1

through Section 2.1.9 Programming Baud Rate for Network

Communication on page 5 for network communication

configuration information.

You can also connect a DX4010i to a serial printer for

report printing. Refer to Section 2.1.10 Programming

Modules 1 and 2 for RS-232 Printing on page 5 and

Section 2.1.11 RS-232 Printer Baud Rate Programming on

page 5 for RS-232 printer configuration information.

You can connect up to two modules to the control

panel; configure as described in Table 1.

Table 1: Module Configuration Combinations

Combination

Number

Module 1

(Address 13)

Module 2

(Address 14)

1 DX4010i

Not used

2 DX4020

Not used

3 DX4020

DX4010i

4 DX4020

DX4020

- Supports both RS-232 printing and RPS direct connect.

- Supports both central station reporting and RPS

programming.

- On Module 2, the DX4010i only supports RS-232

printing.

- On Module 2, the DX4020 only supports central station

reporting.

2.1.1 Network Communication Report Routing

Program whether open and close reports, alarm and

trouble reports, and system reports are routed using

the digital communicator (phone), network

communication (Internet Protocol [IP]), or both.

• Address: 3025

• Data Digit:

• Data Digit 1: ____ (refer to Table 2;

default = 0)

• Data Digit 2: Must = 0

• Selections: 0 to 4

Table 2: Network Communication Report

Routing Options

Select Options 0 1 2 3 4

Disabled

•

Use IP with phone as

backup

•

Use phone with IP as

backup

•

Use IP only

•

Use both phone and IP

•

1 2 3 4 5 6 7 8 9 10

Inhaltsverzeichnis

Seite 1 - Control Panel DS7400XiV4-EXP

Control Panel DS7400XiV4-EXPRelease Notes January 2005Release Notes for Firmware Version 4.10 Trademarks Cobox™ is a trademark of Lantronix. 1.

Seite 2 - DS7400XiV4-EXP

Seite 3

Seite 4

Seite 5

Seite 6

Seite 7

Seite 8

Seite 9

Seite 10

Weitere Dokumente für Sicherheitszugriffskontrollsysteme Bosch DS7400XiV4-EXP

Um das Dokument anzuzeigen Bosch DS7400XiV4-EXP Bedienungsanleitung

Bosch DS7400XiV4-EXP Bedienungsanleitung (40 Seiten)

Um das Dokument anzuzeigen Bosch DS7400XiV4-EXP Betriebsanweisung

Bosch DS7400XiV4-EXP Betriebsanweisung (32 Seiten)

Um das Dokument anzuzeigen Bosch DS7400XiV4-EXP Spezifikationen

Bosch DS7400XiV4-EXP Spezifikationen (144 Seiten)

Kommentare zu diesen Handbüchern

Keine Kommentare

Bosch DS7400XiV4-EXP Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Sicherheitszugriffskontrollsysteme Bosch DS7400XiV4-EXP herunter. Control Panel DS7400XiV4-EXP [en] Benutzerhandbuch

Inhaltsverzeichnis

Weitere Dokumente für Sicherheitszugriffskontrollsysteme Bosch DS7400XiV4-EXP

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Bosch DS7400XiV4-EXP