Bosch LTC 2604 Bedienerhandbuch PDF herunterladen (Seite 43)

IntuiKey Series | Instruction Manual | Appendix B

Bosch Security Systems | 28 June 2004

Camera Functions

Displays a submenu with direct links to various

Camera Functions menus (see FIGURE A-1).

FIGURE B-4 Main Camera Functions Menu

Pressing any camera function softkey causes a second

softkey menu to appear. If the function contains a user-

selectable choice, the options are indicated as two

buttons. The button text represents the options indicated

on the display (e.g. increase/decrease, on/off, etc.).

Upon command completion, or after a time-out of

approximately ten (10) seconds, the softkey display reverts

to the Camera Functions menu. See the table on the next

page for a list of available camera commands as they

apply to the various camera models.

Advanced Menu

Press this softkey to enter the main on-screen

programming menu of G3 and Day/Night Series

AutoDomes having firmware of 2.0 or higher.

Show Shot

Press Keypad Shot, and the status display changes

for input as shown in FIGURE B-5.

FIGURE B-5

Entering a two digit shot number followed by ENTER

selects a previously programmed camera position for the

currently controlled camera.

NOTE: This function is also accomplished by pressing

the SHOT button (located next to the joystick).

FIGURE B-6

Preset Scene Control

This command is specific to G3 AutoDome

cameras; pressing this key displays a camera

on-screen display.

Remove Scene from Tour

Press Clear Shot, and the status display changes to

the display shown in FIGURE B-6.

Not Used

Aux Off

Press this softkey to enter a number associated with

an auxiliary command. The status display changes

to an entry box. See the individual device control

section for details of the Camera Functions menu.

NOTE: If ENTER is held down, the Aux command

auto-repeats until the key is released.

Remove Scene

Allegiant

Show Shot

----

Allegiant

Exit

Pan/Tilt AutoDome

Commands Lens

Commands

Tour AutoDome

Commands Camera

Commands

Factory AutoDome

Default OSD

Commands

AutoDome

General

Commands

R/D AutoDome

Specific Misc.

Commands Commands

1 2 ... 38 39 40 41 42 43 44 45 46 47 48

Kommentare zu diesen Handbüchern

Keine Kommentare

Bosch LTC 2604 Bedienerhandbuch Seite 43

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Bosch LTC 2604