Bosch N46 Bedienungsanleitung PDF herunterladen (Seite 23)

NurseCall N46 Wall Transmitter Operation | en 23

Bosch Security Systems User Manual 970.030 | v1.1 | 2009.09

7 Operation

7.1 Description of the six different states

During operation, the NurseCall N46 Wall Transmitter can be set to one of six following states:

Each state is indicated by the signal lamp and by a special position of the output relays.

It is possible to configure the NurseCall N46 Wall Transmitter in order that:

– the Call for Assistance can be triggered only if the Care Personnel is present.

– the device does not manage the Staff Presence. This mode makes sense only if the

output relays are not provided or not used.

The transition to a specific condition depends on the device configuration, of its actual condi-

tion and of the action completed; as shown on the charts in the following chapters.

State Description

Stand-by No call is being processed.

Alarm without staff presence The patient has triggered a Call for Help but the Care

Personnel has not yet responded.

Alarm with staff presence The Care Personnel has responded after a Call for Help.

Assistance without staff presence A Call for Assistance has been triggered without the

presence of the Care Personnel.

Assistance with staff presence A Call for Assistance has been triggered in the presence

of the Care Personnel.

Staff Presence without alarm The Care Personnel has responded without a previous

call from the patient.

NOTICE!

When the NurseCall N46 Wall Transmitter is powered by an external power supply, the signal

lamps follow the state of the corresponding relay outputs.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 35 36

Keine Kommentare

Bosch N46 Bedienungsanleitung Seite 23