Bosch 1677MDT Spezifikationen PDF herunterladen (Seite 10)

DEPTH ADJUSTMENT

Disconnect plug from power source. Loosen

the depth adjustment lever located between

the guard and handle of saw. Hold the foot

down with one hand and raise or lower saw

by the handle. Tighten lever at the depth

setting desired. Check desired depth (Fig. 3).

Not more than one tooth length of the blade

should extend below the material to be cut,

for minimum splintering (Fig. 3).

m DEPTH, U TMENT

()

ONE TOOTH LENGTH SHOULD

PENETRATE WOOD FOR

MINIMUM SPLINTERING

90 ° CUTTING ANGLE CHECK

Disconnect plug from power source. Set foot

to maximum depth of cut setting. Loosen

bevel adjustment lever, set to 0° on quadrant,

retighten bevel adjustment lever first, then the

depth adjustment lever and check for 90 °

angle between the blade and bottom plane of

foot with a square (Fig. 4). Make adjustments

by turning the small alignment screw from

bottom side of foot, if necessary (Fig. 4).

/Zil ADYsV#ENT

0°--_ /It LEVER

-- ,4 '_ FOOT

BEVEL ADJUSTMENT

Disconnect plug from power source. The

foot can be adjusted up to 45 ° by loosening

the bevel adjustment lever at the front of the

saw and aligning foot to desired angle on

calibrated quadrant. To maintain adjustment,

Always tighten bevel adjustment first, then

the depth adjustment lever (Fig. 5).

For 50 ° cuts, loosen bevel adjustment lever,

depress 45 ° stop spring, adjust foot to 50 °

and tighten lever (Fig. 5). Because of the

increased amount of blade engagement in the

work and decreased stability of the foot, blade

binding may occur. Keep the saw steady and

the foot firmly on the workpiece.

45° STOP BEVEL

SPRING ADJUSTMENT

LEVER

m

PUADRANT

LINE GUIDE

For a straight 90 ° cut, use the large notch in

the foot. For 45 ° bevel cuts, use the small

notch (Fig. 6). The cutting guide notch will

give an approximate line of cut. Make sample

cuts in scrap lumber to verify actual line of

cut. This will be helpful because of the

number of different blade types and

thicknesses available. To ensure minimum

splintering on the good side of the material to

be cut, face the good side down.

90° VERTICAL CUTS

F

i

FO!OT I 1_45°/50°BEVELCUTS

PUSH

I _\-_ t • 45°STOP

II I I- III " SPRING IN

D,RECT,ON

IY,LZ_JJ_ / _1 OFARROW

IFFq_ £ ( !_]_[T_I FOR50°

It=LJ //_, I i_l BEVEL

I1\t/ /t 3 I/ I\1/ I \1/ I\ll ADJUSTMENT

-10-

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 43 44

Kommentare zu diesen Handbüchern

Keine Kommentare