Bosch SE2005 Einstellungsanleitung PDF herunterladen (Seite 38)

Security Escort | Installation and Setup Guide |4.0 System

Power-u

and Debu

EN | 38

Bosch Security Systems | 1/09 | 33831E

4.0 System Power-up and

Debug

4.1 Initial System

Configuration

Refer to the section Initial System

Configuration in the document titled

Security Escort Technical Reference

Manual (P/N: 38947) to configure the

software. Transfer the information

from the installation data sheets to

the Transponder Database and assign

the Comm ports to the SE485 bus or

ProxLink Radio. Make sure that the

databases are backed-up using the

Utilities Menu→Backup selection.

Back-up the databases whenever they

change, and keep multiple copies.

4.2 Powering Up the System for

the First Time

After the system is configured, the

system may be powered up. If the

system uses multiple transponders, it

is easier and more effective to power

up the transponders one at a time. By

doing this troubleshooting time can be

significantly reduced, especially if

there is a wiring problem in the SE485

bus between transponders.

Note:

It is very important that twisted

pair wiring is used for the SE485

bus. The Tx+ and Tx- wires must be

twisted together and the Rx+ and

Rx- wires must be twisted together.

1. Turn on the power switch on the

first transponder. In the Security

Escort central console software

select Setup Menu→ Transponder

Current Status. The screen shown in

Figure 18 appears:

Figure 18: Current Transponder Status Screen

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 53 54

Kommentare zu diesen Handbüchern

Keine Kommentare

Bosch SE2005 Einstellungsanleitung Seite 38

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Bosch SE2005