Bosch 7000 Series Handbuch PDF herunterladen (Seite 27)

 Bosch Alarm Panel Interface Manual

Revision 1.4

8.3.4 Managing Properties of the Alarm Panel Connection

User can edit the IP parameters and connection settings from the Connection Properties window. User

can also configure the encryption settings from this window.

FIG 11b: Connection Properties screen

The parameters in this screen are originally

programmed in the Alarm Panel Properties

screen and saved in the SG database (Refer

to Section 5).

NOTE: Two important check boxes

appear at the bottom of the Connection

Properties screen:

ª The “Auto-Connect when service

starts” option: When checked the

selected

alarm panel will be

automatically connected whenever

the Alarm Panel Service starts.

ª The “Auto-reconnect” option

When checked the Alarm Panel

Service will automatically attempt

reconnect to the selected panel

when the panel becomes

disconnected.

Also user can access the Encryption Settings

from this screen by pressing the [Encryption

Settings] button.

When the [Encryption Settings] button is

pressed this dialog box opens.

a. key length = 128 (default) ; must be zero

if not used.

b. must specify a key value: the key value

is a 16 digit hex code; must be blank if not

used.

Page 27 of 37

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 36 37

Keine Kommentare

Bosch 7000 Series Handbuch Seite 27