Bosch DS7447 Betriebsanweisung PDF herunterladen (Seite 26)

– 26 –

Optional Operations (continued)

Day to Day Operations (continued)

Setting the System Clock

Setting the time on the System Clock can only be done in Master Programming Mode, so it is not programmable from an RF (wireless)

keypad.

Note: You should write down your entries before you enter the Master Code Programming Mode and have them with you as you begin

programming. Make your entries promptly. If a delay of 15 seconds or more occurs between your entries, the 3-beep error tone

occurs and exits you from the programming mode.

It is recommended that this procedure be performed at a DS7447/DS7447E keypad. No visual clues will be given from a

DS7445/DS7445i keypad.

Note: Entering the command sequence [Master Code] [#] [0] [6] [#] will cause the DS7447/DS7447E keypad to display the time.

* = This will display only when in Single Partition Mode.

Steps to Set the Time Command Sequence If Accepted, DS7447/DS7447E Display

Reads:

Enter Master Programming Mode. [Master PIN] + [#] [0] “6 Change Time” *

(display will scroll to this)

Enter a 6 for System Clock Setup

programming

[6] “Enter Day”

(1 … 7)

Enter the Day. [1] through [7]

Sunday Saturday

“Enter Time”

(0100 … 1259)

Enter the Time. [0] [1] [0] [0] through

[1] [2] [5] [9]

“Enter AM/PM”

(4/6) End with #

Enter AM or PM. [4] [#] for AM or

[6] [#] for PM

“Day – Time”

A long beep signifies acceptance.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 59 60

Keine Kommentare

Bosch DS7447 Betriebsanweisung Seite 26