Bosch DS7447 Betriebsanweisung PDF herunterladen (Seite 34)

– 34 –

Personal Identification Numbers (continued)

Changing a PIN

PINs can only be changed in Master Programming Mode, so they are not programmable from an RF (wireless) keypad.

Note: You should write down your entries before you enter the Master Code Programming Mode and have them with you as you begin

programming. Make your entries promptly. If a long delay occurs in your entries, the 3-beep error tone occurs and exits you from the

programming mode.

It is recommended that this procedure be performed at a DS7447/DS7447E keypad. No visual clues will be given from a

D7445/DS7445i keypad.

Note: If a Master PIN is not assigned to at least all the areas that the PIN being changed is assigned to, the Master PIN will not be allowed

to alter that PIN.

continued on next page

Steps to Change a PIN

Command Sequence If Accepted, DS7447/DS7447E Display

Reads:

Enter Master Programming Mode. [Master PIN] + [#] [0] “0 User Change”

(display will scroll to this)

Enter a 0 for PIN Setup programming. [0] “Enter User No”

(001 … 200)

Enter the User Number. [0] [0] [1] through [2] [0] [0] “Enter Authority Level”

Level (0-6)

Enter the Authority Level. [0] through [6] “Enter Area(s) or # for all”

Enter the Area(s) (Partitions) to which

this user will have access.

[1], [2], [3], [4], [5], [6], [7], and/or [8]

followed by [#]

“Enter Next Area, End with #” or

“Enter PIN”

Enter the PIN. Any 4 or 6 digits.

not

press [#].

“Enter PIN Again. End with #”

A long beep signifies acceptance of the PIN.

Enter the PIN again followed by [#]. [PIN] (same 4 or 6 digits as previous step)

then [#]

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 59 60

Keine Kommentare

Bosch DS7447 Betriebsanweisung Seite 34