Bosch LTC 8555 Bedienerhandbuch PDF herunterladen (Seite 24)

Bosch Security Systems | December 8, 2004

LTC 8100, LTC 8200, LTC 8300 Series | Instruction Manual | Optional Accessories

7. 0OPTIONAL ACCESSORIES

7.1 Logging Printer Option Installation

NOTE: Installation for each printer varies; the following

steps are generally required. Save the printer reference

manual for procedures not covered.

•Switch the main power to the printer OFF.

•Install ribbon cartridge and paper if necessary.

•Set any configuration switches for your particular

printer to match the format provided by the

LTC 8300 Series system.

• The system communication protocol can be

changed via keyboard User Function 31

(see Section 13, KEYBOARD USER FUNCTIONS),

the optional LTC 8059/00 MCS for Windows or

the LTC 8850/00 GUI software. Factory default

values are as follows:

Baud rate 19,200

Stop bits 1

Data bits 8

Parity None

• The required interconnect cable uses a custom

pinout. Refer to APPENDIX D for wiring details.

1. Attach the 25-pin male D-type connector side

of the RS-232 cable to the connector on the

printer.

2. Attach the 9-pin male connector side of the

cable to the LTC 8300 Series bay connector

marked PRINTER.

• Apply power to the printer.

•Verify printer logging by loading a previously

stored sequence into a monitor, activating an

alarm, or performing a system reset. Any of these

actions should cause printouts to occur.

7. 2Windows-compatible Computer

Interface Installation

NOTE: Installation for each computer varies; the

following steps are generally required. Save the computer

reference manual for procedures not covered here.

•Switch the main power to the computer OFF.

•Attach the PC security key, provided with the

MCSfor Windows or the LTC 8850/00 GUI

software kit, to the computer.

• The supplied interconnect cable uses a custom

pinout. If it ever becomes necessary to replace the

cable, it can be ordered separately (part number:

LTC 8506/00). Alternatively, a cable can be

configured using the information in APPENDIX D.

1. Attach one end of the supplied interface cable

to the Allegiant bay connector marked

CONSOLE.

2. Attach the other end of the cable to an

available serial port (COM1 or COM2) on the

rear of the computer.

• Apply power to the computer and allow it to boot

up its operating system before inserting the MCS

or GUI software disc.

•Refer to the LTC 8059/00 MCS or LTC 8850/00

GUI software reference manual for operating

instructions.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 63 64

Kommentare zu diesen Handbüchern

Keine Kommentare

Bosch LTC 8555 Bedienerhandbuch Seite 24

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitszugriffskontrollsysteme Bosch LTC 8555