Bosch FPA-1200-MPC Betriebsanweisung PDF herunterladen (Seite 34)

100

Networked panels

Panels can be networked with one another via a CAN bus or an Ethernet connection. This

chapter describes the similarities between the two physical networking principles. Detailed

notes on networking via Ethernet can be found in Networking via Ethernet, page 37. Details

on planning and commissioning are provided in the network manual. Fire detection systems

can only be networked with the FPA‑5000.

– Icons on the display, page 34

– Network addressing, page 34

– Establishing a remote connection with a networked panel, page 35

– Terminating a remote connection with a networked panel, page 35

– Isolating and restricted connection, page 35: A restricted connection can be established

with a panel that is already operated by another panel (isolating connection).

– Networking via Ethernet, page 37

The following functions cannot be carried out on a panel that is operated by another panel:

– Bypass

– Isolate

– Switch to Walktest

– Change configuration

You can reset elements and read out the history log.

Icons on the display

The following icons are displayed in the standby display/info bar/list field of a networked

panel, depending on the type of connection. Further explanations of the icons can be found in

Establishing a remote connection with a networked panel, page 35.

There is a remote connection between panel A or a remote keypad and

a networked panel B .

The networked panel B is operated from panel A or from a remote

keypad and is isolated for operation.

The networked panel B, with which panel A or a remote keypad has

already established a remote connection, in turn establishes a remote

connection with a networked panel C.

There is a restricted remote connection with a networked panel.

Network addressing

In the case of a networked panel, the network address is also displayed. The network address

consists of a node ID and group ID, which are assigned using the FSP-5000-RPS programming

software.

If, for example, a fault in a detector with network address 1 - 4 is displayed, this means:

– Group ID = 1

– Node ID = 4

6.1

6.2

34 en | Networked panels Panel Controller

2013.07 | 3.0 | F.01U.258.929 User Guide Bosch Sicherheitssysteme GmbH

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 99 100

Kommentare zu diesen Handbüchern

Keine Kommentare

Bosch FPA-1200-MPC Betriebsanweisung Seite 34

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Fernbedienungen Bosch FPA-1200-MPC