Bosch Remote Control Bedienungsanleitung PDF herunterladen (Seite 23)

I-Remote Running a Remote Session 5-5

DOK-IWORKS-IREMOTE*V01-AW01-EN-P

FERNWART_START_03.bmp

Fig. 5-6: Configuration of a client connection

FERNWART_START_04.bmp

Fig. 5-7: Entering the IP Address of the control unit

Run the IPCONFIG program on the DOS command line on the control

system to determine the IP address of the control system.

If you are communicating via a remote data communication connection

with the control system, then you can also determine the IP address of the

WAN adapter via the RAS server configuration.

Note: When using a DHCP server, the IP address of the control unit

may change after expiration of a lease time. In this case, you

must correct the IP address on the client configuration in the

NetSupport control.

Speak to your network administrator if you want to assign the

control unit with a fixed IP address.

Enter the computer name for the

new client and set the storage

location to local

Activate the TCP/IP transport

protocol and enter the IP

address or the computer name

of the control unit

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 59 60

Keine Kommentare

Bosch Remote Control Bedienungsanleitung Seite 23