Bosch Remote Control Bedienungsanleitung PDF herunterladen (Seite 30)

7-2 System Overview I-Remote

DOK-IWORKS-IREMOTE*V01-AW01-EN-P

I-Remote within a Local Network

If the service PC is in the same LAN as the control unit, then the remote

session can be run without any additional adjustment of the network. It is

thus irrelevant whether the service PC and the control unit are in different

subnetworks or not. In this case, the IP packages are routed between the

individual subnetworks.

If a former stand-alone control system group such as that shown below is

connected to the head station with the LAN, then appropriate adjustments

must be made to allow for communication between the service PC and

the group.

In the configuration shown, the head station is a multihomed system with

2 network interface cards. Even without use of a router, communication

between a control system group and the adjacent subnetwork can be

established within this configuration. IP forwarding must first be activated

at the head station. Then the head station must also be accepted into the

TCP/IP configuration as an additional gateway on the service PC and on

the control systems of the group. After this adjustment, the control system

groups can be remotely operated by the service PC.

TeleserviceLAN.JPG

Fig. 7-2: I-Remote within a local network

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 59 60

Keine Kommentare

Bosch Remote Control Bedienungsanleitung Seite 30