Bosch SF8172V Spezifikationen PDF herunterladen (Seite 59)

American Dynamics Fixed Camera (Illustra 210, Illustra 600 and Illustra 610 Domes)

21-4 Camera Handler Release Notes

•Illustra 210 = H.264, Maximum available Fps, D1

•Illustra 600 = H.264, Maximum available Fps , 1280X720

•Illustra 610 = H.264, Maximum available Fps , 1920X1080

• The camera will not add after password is changed and correct password group is selected. This

issue happens intermittently.

• Any interruption to video stream on the I6x0 Minidome series (stream setting change, camera

reboot or camera loss of power) will result on Edge Connection being interrupted even if it will

still shows as active on NVR configuration. Just disable and enable the “Edge Motion Detection

Alarms” configuration by the NVR alarm tab will restore the connection.

• Setting up Edge Motion on the i6x0 Mini-Dome Cameras via the set up below (Scenario 2) may

cause Edge Motion not to trigger correctly.Please follow the work around if you intend to set up

your camera using Scenario 2. Otherwise you can use Scenario 1.

1 Scenario 1 - Motion Triggers

• Add camera as default Single Stream - H264

• Enable Edge Motion and configure NVR alarms page (assuming motion is

already setup on the camera)

• Motion will always trigger

• Enable Stream 2 Alarm / Record as MJPEG (usually MJPEG, 7, CIF)

• Motion will always trigger

2 Scenario 2 - Motion does not Trigger

• Add camera as default Single Stream - H264

• Enable Edge Motion and configure NVR alarms page (assuming motion is

already setup on the camera)

• Motion will always trigger

• Enable Stream 2 Alarm / Record as H264 also.

•Motion will not trigger.

• At this stage the camera is in a state. Even if you now change Stream 2 to

MJPEG, Edge motion will still not trigger.

Workaround for Scenario 2:

• After setting both streams to H264, go back to the Alarm Configuration page on

the NVR

• Disable Edge Motion and Save

• Re-enable Edge Motion and Save

• Motion will now trigger.

Special Points

• Some properties are normalized to a percentage (1-100), but the real value in camera is a range

from -127 to 128. This results in the values in the NVR not covering all values in the camera.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 174 175

Keine Kommentare

Bosch SF8172V Spezifikationen Seite 59